|
| (1)
rigolen pipe |
| (2)
rigolen shaft |
|
(3) Shaft increase |
| (4)
house connection |
|
(5) PROFILEEN ® easy cut |
 (6)
double sleeve |
| (7)
rigolen shaft |
Rigolen systems are needed wherever the sealed areas (streets,
buildings, parking lots etc.) have to be supplied with
rain water again. So on the one hand the sinking of the
ground-water level and on the other hand an overload of
the drainage systems is prevented. |
|
 |
| The
PROFILEEN ® system provides the planner with a variety of
construction elements to make the optimal solution for every
case possible. |
| |
|
| 
|
|
(1)
PROFILEEN ® rigolen pipes
The profiled pipes can be delivered in a diameter range from
300 mm up to 1600 mm. The standard construction length is
6 m and the pipes have a sleeve and a spigot standardly for
easy connection.
Different perforation diameter are available. The perforation
can be attached on either 2/3rd or 3/3rd of the pipe size.
|
| |
|
| |
|
(2)
PROFILEEN ® rigolen shaft
The bottom/lower part of the shaft can be produced without
ground for free drainage but also with the perforated ground.
The shaft has outside lying pipes for connecting pipes. The
standard construction height is 1000 mm + DN pipe. Provided
that a deposition chamber shall be integrated in the shaft
it is standardly 500 mm deep (calculated from pipe bottom).
The shaft itself can also be made with perforation for the
drainage. |
| |
|
 |
|
(3)
PROFILEEN ® shaft increase
The increase element of the rigolen shaft has a maximum construction
length of 2000 mm and a sleeve for the connection to the top
edge of the rigolen shaft. Shaft and increase are closed to
the top edge area with a load turn away plate and a shaft cover
which must be put on the job site. |
| |
| |
(4)
PROFILEEN ® house connection
This fitting comes from the sewage area (see products: sewer
technology) and can also be used for the connection of rain
water pipes without any problems. |
| |
|
| |
|
(5) PROFILEEN ® easy cut
This pipe comes from the sewage area (see products: sewer
technology) and is provided with the same perforation
like the rigolen pipe in this case. The standard construction
length is 6 m, the pipe can be shortened at will and it can
be connected to the next pipe with a double sleeve.
|
| |
|
| |
|
(6)
PROFILEEN ® double sleeve
This fitting comes from the sewage area (see products: sewer
technology) and matches on the one hand to the easy cut
pipe and on the other hand to the spigot of the normal profiled
pipe. |
| |
|
| |
|
(7)
PROFILEEN ® rigolen storage
For financial reasons or because of the limited place conditions
the pipe cross-section calculated for the drainage cannot always
be layed. The rigolen storage which can be installed in any
place in the pipe network solves the problem. When it is raining
the water is stored in this buffer and it is slowly been given
to the ground by the perforation. |
